The startup configuration is provided below for each switch in the topology.īanner motd # D1, STP Topology Change and RSTP Lab # Console into each switch, enter global configuration mode, and apply the basic settings and interface addressing.Step 2: Configure basic settings for each switch. Step 1: Cable the network as shown in the topology.Īttach the devices as shown in the topology diagram, and cable as necessary. In Part 1, you will set up the network topology and configure basic settings and interface addressing on routers. Instructions Part 1: Build the Network and Configure Basic Device Settings and Interface Addressing Ethernet cables as shown in the topology.Console cables to configure the Cisco IOS devices via the console ports.

1 PC (Windows with a terminal emulation program, such as Tera Term).1 Switch (Cisco 2960+ with Cisco IOS release 15.2 lanbase image or comparable).2 Switches (Cisco 3650 with Cisco IOS XE release 16.9.4 universal image or comparable).If you are unsure contact your instructor.Īnswers Note : Refer to the Answers Lab Manual for the procedures to initialize and reload devices. Note : Ensure that the switches have been erased and have no startup configurations. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in th e labs. Other routers and Cisco IOS versions can be used.

Note : The switches used with CCNP hands-on lab s are Cisco 3650 with Cisco IOS XE release 1 6.9.4 (universalk9 image) and Cisco 2960+ with IOS release 15.2 ( lanbase image). It does not reflect networking best practices. Note: This lab is an exercise in deploying and verifying various STP mechanisms. The terms “switch” and “bridge” will be used interchangeably throughout the lab. In this lab, you will observe the operation of spanning tree protocols to protect the Layer 2 network from loops and topology disruptions. Layer 2 loops can be prevented by following good design practices and careful implementation of the Spanning Tree Protocol. Layer 2 loops could impact connected hosts as well as the network equipment. The potential effect of a loop in the Layer 2 network is significant.

Part 3: Configure and Verify Rapid Spanning Tree Background / Scenario Part 2: Observe STP Convergence and Topology Change Part 1: Build the Network and Configure Basic Device Settings

Packet tracer labs spanning tree